If the fu se does not have continuity replace it.
Maytag bravos xl mct washer won t start.
I have a maytag bravos xl washer that is leaking water.
Check your owner s manual for information on your specific model.
Close lid and press start.
Maytag bravos washer will not continue to the next cycle after the wash cycle.
In addition you should investigate and resolve the problem that caused the fuse to blow.
To correct the overload remove several items and add detergent.
The washer has attempted to fill and begin a wash cycle.
A bad lid switch will make it so power cannot get to the drive motor.
To determine if the thermal fuse is at fault use a multimeter to test it for continuity.
Water level switch the water level switch aka pressure switch controls the water level.
If the timer is defective the motor will not turn therefore no washer agitation.
It does not look to be coming from a hose.
If the washer starts and seems to progress through the cycle well but doesn t move to the spin cycle the problem may be with the locking lid switch.
Depending on your model some washers may fill without the lid locking and others will not even start until the lid locks.
The lid must be completely closed and latched for the washer to operate.
I set it up on blocks so i can see under it and looks to be coming from the basket underneath when th.
The maytag bravos washers come in different models with each model experiencing unique problems.
Common problems with maytag bravos washers include failure to start water filling slowly water leakage failure of the door or lid to lock and overflowing.
If the washer is overloaded it will drain any water and detergent that was added during the fill.
Other problems include stopping at mid cycle loud noise and failure to drain and spin.
I have a maytag bravos washer mtw6600tq0 that won t start.
I have a mct bravo xl and it won t start a new load it is stuck on deep water and won t start.
If the line fuse blows the washer won t start.
